The official stock firmware for Motorola Edge 30 XT2203-1 is now available and you can download it from below. Using this firmware you can solve all software issues in your Motorola Edge 30 XT2203-1 such as hang on logo, FRP lock, fast boot mode, blank or white display after flash, dead recovery, flash After the dead, etc.
The Motorola Edge 30 XT2203-1 runs on Android 12 and is powered by QCOM SD778. It is a dual SIM smartphone support Nano SIM card, connectivity features include GPS WiFi hotspot Bluetooth 3G 4G and 5G. The device comes with 8 GB RAM and 128 GB storage which can be expanded via SD card.
Pre-Requirement’s
- First Make a complete backup of device
- charge the device at least 50% to prevent accidental shut down during the process
Firmware Information:
- Device Name: Motorola Edge 30 XT2203-1
- Type: Full ROM
- Size: up to 2-4GB
- SoC: QCOM
- Os: Android 12
- Password: Null
- Root access: Not
- Gapps: Included
- Carrier: Check Below List
- Firmware Version: DUBAI_G_S1RD32.55-67
Download Links:
- Retail Asia: Download
Flash Tools:
usb Driver:
- usb driver: Download
How to Install Stock Firmware on Motorola Edge 30 XT2203-1:
- Download & Extract Firmware & RSD Lite tool
- Install RSD Lite and usb driver on your computer
- after extracting the Firmware you will see an XML file “XXX” then open the file with notepad. Remove all lines with the word “getvar” there were two lines that have the word “getvar”, then save. (Note: Skip if No getvar)
- Open RSD Lite, Press the “…” Next to the Filename. Find and select the XML file that has been edited in step No.3
- Reboot phone to bootloader by pressing volume down & power key
- Connect Phone to computer by using the usb cable
- Click Download/start, wait until done. once done unplug Phone and switch it ON
Method 2:
- Reboot phone to bootloader by pressing volume down & power key
- Connect Phone to computer by using the usb cable
- Go to firmware folder and Run flash-all.bat wait until success, once done disconnect device and switch it ON..
Note: if the device is bricked or no fastboot access then first write blank flash then write fastboot firmware..